- #SONOS CONNECT AMP INSTALL INSTALL#
- #SONOS CONNECT AMP INSTALL PORTABLE#
- #SONOS CONNECT AMP INSTALL SERIES#
If your TV has an HDMI ARC port, connect the HDMI cable directly to the TV’s HDMI ARC port. Note: You may need the optical adapter too (the app lets you know).įully insert the HDMI cable into Amp’s HDMI port.Ĭonnect the HDMI cable to your TV.
When connected, Amp creates two front audio channels and plays your TV sound through your favorite non-Sonos speakers. Use an HDMI cable to connect Amp to your TV.
If you don’t have the Sonos app, download it from your app store. You’ll use our app to set up and control your Sonos system.
#SONOS CONNECT AMP INSTALL INSTALL#
Repeat to install the other speaker wires. Insert the banana plug into the proper speaker terminal on the back of Amp. Mismatching of polarities will result in weak central sound and a distorted sense of sound direction. Note: Connect the red (+) and black (-) terminals from each speaker to the corresponding banana plug and terminal on Amp. Insert the stripped end of the speaker wire into the hole, then return the cap to the banana plug to secure the connection. Remove the cap from the banana plug to reveal the connection hole.
#SONOS CONNECT AMP INSTALL SERIES#
Don’t wire your speakers in series because it will result in poor sound quality. Two pairs of 8 ohm speakers wired in parallel are also supported. Note: Amp can drive speakers with nominal impedance above 4 ohms. Do not connect speakers rated at less than 4 ohm. Your speakers’ power rating should be at least 125W for 8 ohm speakers, and at least 200W for 4 ohm speakers. If put on a shelf, place at the front and keep 3" (minimum) clearance on all sides.ĭon’t block the front of Amp so you can reach the touch controls. Place horizontally on a stable and level surface at least 3 in / 50 mm from the TV. Place two Amps side by side in a 2U rack. You can place Amp just about anywhere- in an electronics rack, on a shelf, or on a credenza with your TV.Īmp mounts perfectly in any electronics rack. See Connect Amp to your TV for setup information. (For even deeper sound, add a Sonos Sub or connect a third-party subwoofer.) Use Amp with third-party speakers to add surround sound if you already have a Sonos home theater speaker (Beam, Playbase, Playbar, or another Amp) connected to your TV. Use Amp and a pair of 3rd-party speakers to create two front audio channels.
#SONOS CONNECT AMP INSTALL PORTABLE#
Connect a turntable, stereo, or portable music player and play the sound on any Sonos speaker.Ĭonnect Amp to your TV to create the ultimate entertainment system. Play music through your favorite speakersĬonnect your favorite bookshelf, floor-standing, in-wall, or in-ceiling speakers to Amp to stream all the music you love. Use high-quality speaker wire to connect your speakers to Amp. The system will detect when a cable is connected to the subwoofer output and adjust the crossover frequency automatically.
Note: If you disconnect your subwoofer, make sure to also disconnect the subwoofer’s cable from the Amp output.Ĭonnect a powered subwoofer to this output using a standard RCA cable.
Use an Ethernet cable if you want to connect to a router, computer, or network-attached storage (NAS) device (optional). Use a standard RCA audio cable to connect Amp’s analog audio inputs to the audio outputs from a separate audio component, such as a turntable or a portable music player. Use only the supplied power cord (using a third-party power cord will void your warranty). Use an HDMI cable to connect Amp to your TV’s HDMI ARC port.
0 kommentar(er)
